Air Duct and Dryer Vent Cleaning South Ogden UT homeowners can count on starts with a full inspection, not a sales pitch. We pull lint and dust from your dryer vent and clear buildup from your supply and return ducts so your HVAC system breathes easier. If you have noticed musty odors, weak airflow, or a dryer that takes two cycles to finish a load, our dryer vent and duct cleaning in South Ogden is built for exactly that.
Air Duct and Dryer Vent Cleaning South Ogden UT is a two-part service that removes lint, dust, and debris from your dryer exhaust line and your home's HVAC ductwork. On the dryer side, we disconnect the vent, run a rotary brush and air whip through the full run, and pull the loosened lint out with a negative air machine and HEPA vacuum. On the duct side, we open every register, feed a duct camera through the trunk lines, and scrub flexible duct and sheet metal duct back to bare metal.
Most South Ogden homes we service were built between the 1950s and the 2000s, and that range matters. Older homes near Adams Avenue District often have original sheet metal duct with decades of dust buildup, while newer builds in Shadow Valley tend to use flexible duct that sags and traps pet dander. If you have been searching for air duct and dryer vent cleaning South Ogden UT near me and keep finding companies that only do half the job, we handle both lines in one visit.
Every job includes the full dryer vent run and every accessible supply and return duct. Add-ons like coil cleaning and sanitizing are quoted upfront if your inspection shows they are needed.
We disconnect the dryer, brush the entire vent run with a rotary brush and flexible duct rod, and vacuum out the loosened lint with a HEPA vacuum. We verify airflow at the exterior termination before reconnecting.
Every accessible register gets opened and cleaned. We scrub trunk lines and branch runs with air whips and rotary brushes while a negative air machine holds containment, then re-seal each register cover.
Before and after footage of your main trunk lines and dryer vent run. You see what we see. If there is pest nesting in ducts or mold growth in ducts, it shows up on camera and we walk you through the options.
We swap in fresh HEPA filters or MERV filters matched to your system. A clogged filter undoes a cleaning fast, so we make sure you start with a clean one and tell you the right replacement interval.
After cleaning, we measure airflow at the furthest register and at the dryer termination. You get written readings. If a number is low, we investigate before we pack up, not after we leave.
For homes with musty odors or prior moisture issues, we apply an EPA-registered sanitizing fogger to the trunk lines. This is quoted separately and only recommended when the inspection supports it.
We start with a duct camera inspection of your main trunk lines and the full dryer vent run. You see the footage on our screen. If the ducts are clean, we tell you and we do not sell you a cleaning you do not need. This step takes 15 to 20 minutes and sets the scope for everything that follows.
We lay drop cloths, seal every register with register covers, and hook a negative air machine to the main trunk. That machine keeps dust from drifting into your living space while we work. Setup takes about 20 minutes, and you will not see dust settling on furniture when we are done.
We disconnect the dryer, run a rotary brush and flexible duct rod through the full vent, then follow with an air whip and compressed air nozzle. A HEPA vacuum captures everything we loosen. Most dryer vent runs take 30 to 45 minutes, longer if the line routes through an attic or has multiple elbows.
Working register by register, we scrub supply and return lines with rotary brushes and air whips while the negative air machine holds suction. Sheet metal duct gets brushed to bare metal; flexible duct gets a gentler pass so we do not damage the liner. A typical 2,000-square-foot home takes two to three hours.
We apply an EPA-registered sanitizing fogger to the trunk lines, swap in fresh HEPA filters or MERV filters, and re-check airflow at every register and at the dryer termination. You get before-and-after camera footage and a written airflow reading. If a number looks off, we find out why before we leave.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Hooks to the main trunk and pulls air out of the system while we work. It keeps dust and debris from drifting into your living space during cleaning.
Captures fine particles the negative air machine pulls out, including dander and drywall dust. HEPA filtration is what makes the containment actually work.
The rotary brush scrubs duct walls while the air whip blasts loosened debris toward the vacuum. Together they clean sheet metal duct and flexible duct without damaging the liner.
Lets us see inside the trunk lines and dryer vent run before and after cleaning. You watch the footage with us, so there is no guesswork about what was removed.
Reaches deep into long dryer vent runs and around elbows where a brush alone cannot travel. Essential for vents routed through attics or crawlspaces.
Applies an EPA-registered sanitizer to trunk lines when the inspection shows mold growth in ducts or persistent musty odors. Used only when it is warranted.
Cleans register covers, diffusers, and tight corners the brush cannot reach. We use it after the main cleaning pass to catch what is left behind.
A homeowner in Burch Creek was running the dryer twice per load and the exterior flap barely moved. The vent run had not been cleaned in at least six years. Camera footage showed the line nearly blocked with compacted lint about eight feet from the termination.
We brushed and vacuumed the full run, cleared the termination, and measured strong airflow at the exterior flap. The dryer returned to a single-cycle dry time the same afternoon. Total job time was under an hour.
A family near the Adams Avenue District had visible dust on furniture within two days of cleaning. The home still had original sheet metal duct, and the return trunk had never been cleaned. Camera inspection showed a thick layer of dust and pet dander coating the entire return line.
We cleaned every supply and return run with negative air containment, scrubbed the trunk to bare metal, and replaced the filter with a MERV 11. Dust settling on furniture dropped noticeably within the first week.
A homeowner in Shadow Valley finished a basement remodel and drywall dust was coating every surface, including inside the vents. The blower compartment was caked with fine white dust and the filter was completely clogged.
We cleaned all supply and return runs, cleaned the blower compartment, and installed a fresh filter. The white dust stopped settling within two days, and airflow at the far registers returned to normal.
Most duct and vent problems announce themselves long before they become expensive. Here are the ones we see most often in South Ogden homes.
Ask a pro →We brush and vacuum the full vent run, clear the exterior termination, and verify airflow. Most dryers return to a single-cycle dry time the same day. If the run is too long or has too many elbows, we tell you what needs to change.
We inspect with a duct camera, clean the affected runs, and apply an EPA-registered sanitizing fogger where the inspection supports it. If the source is a moisture problem, we point it out so it does not come back.
We clean the returns and supply runs with negative air containment, so debris leaves the system instead of your living room. Fresh MERV filters and a clean blower compartment keep it from returning as quickly.
We remove the buildup at the source and recommend filtration matched to your household. For homes with pets, we often suggest a shorter cleaning interval and a higher-MERV filter to keep the air cleaner between visits.
Most homes run $350 to $700 for both services combined in 2026. A single-family home under 2,000 square feet with one HVAC system sits at the lower end. Larger homes, multiple systems, or heavy buildup push the price toward the top of that range. Dryer vent cleaning alone typically runs $125 to $225.
Yes, when you book the combined service. We clean the full dryer exhaust run and every supply and return duct in the same visit. If you only need one, we will tell you after the camera inspection. We do not bundle services you do not need just to raise the ticket.
Fluxvia provides both services across South Ogden and Weber County, including Burch Creek, Country Hills, and the Riverdale Road Corridor. We are licensed through Utah DOPL and carry EPA Lead-Safe Certification for older homes. Call (855) 927-7517 and we will confirm availability for your address.
Dryer vents should be cleaned every 12 months, or every 6 months if you have a large household or long vent run. Ducts need cleaning every 3 to 5 years for most homes. If you have pets, allergies, or recent remodeling, shorten those intervals. We will give you a specific schedule after the inspection.
Air Duct Cleaning Near MeIf you searched air duct cleaning near me and landed here, we cover the full duct system, not just the visible registers. We clean trunk lines, branch runs, and returns in one visit so your whole system is addressed.Explore →
24/7 Air Duct CleaningDryer vent blockages do not wait for business hours. Our 24/7 line handles urgent calls across South Ogden, including evenings and weekends, when a dryer stops heating or airflow drops to nothing.Explore →
Emergency Air Duct CleaningWater intrusion, pest nesting, or a burning smell from the vents calls for emergency service. We respond fast, isolate the problem, and clean the affected runs before contaminants spread through the rest of the system.Explore →
Residential Air Duct CleaningSingle-family homes, townhomes, and duplexes across South Ogden get the same full-system treatment. We size the equipment to your home and clean every register, not just the ones that are easy to reach.Explore →
Commercial Air Duct CleaningRestaurants, offices, and retail spaces along Riverdale Road Corridor need duct cleaning on a schedule. We work after hours to avoid disrupting your business and document everything for your records.Explore →
HVAC Duct CleaningDuct cleaning is only half the picture if your air handler is dirty. We clean the blower compartment and ductwork together so the system is not recontaminating itself the moment it runs.Explore →
Furnace and Duct CleaningBefore heating season, we clean the furnace cabinet, blower, and ductwork as one job. That combination keeps dust from the ducts out of your freshly cleaned furnace.Explore →
Air Vent CleaningRegister covers and diffusers collect dust that blows back into the room. We pull and clean each vent, then re-seal it so the supply air stays clean.Explore →One visit covers both your dryer vent and your full duct system, with camera proof before and after. We are licensed, insured, and upfront on price. Call (855) 927-7517 and we will get you on the schedule, often the same day.
Schedule Service (855) 927-7517 →Call (855) 927-7517 or email info@fluxvia.com and we will get you on the schedule, usually the same day you reach out. We answer the phone between 8 a.m. and 6 p.m. on weekdays, and emergency dispatch runs 24/7 for water, pest and puffback calls.